Methods of sugarcane cultivation

Before sowing, refine the seed.  Soak the sugarcane pieces in a special solution (150 g of carbendazim + 200 m, 100 g of chloropyrifos + 1 kg, gr, urea in 100 liters of water) for 15 to 20 minutes and then take out the seeds and apply them to the soil.  This can be used to control the disease, and to keep the sugarcane from growing.  If the acu seeds can be treated with a 54-degree Celsius hot bump for 2 to 2.5 hours, blackheads (smut), grassyshootdisease, and red leaf disease can be managed.

 How to plant sugarcane

 Flat plate method.

 This is a traditional method.  The soil is first cultivated with two or four oats and the soil is well fertilized.  The plow is then plowed with maize, while the plow is cut with native plow.  The depth of the sieve is 10 to 15 ° C, m.  The sugarcane pieces are leveled with oil after throwing.

 Farmers face a number of problems with sugarcane cultivation.

 It takes more seed.

 There is less germination.

 Due to the muddy water, many of the seeds in the eyes rot.

 Not all heads in the field have the same amount of water.

 Due to the delay in the growth of the cane, the prevalence of weeds increases.

 Late application of wounds can significantly reduce yields

 Eating and eating.

 This method of planting sugarcane as a result of rapid agricultural mechanization is gaining popularity among the farmers.  In this way the land is first cultivated and leveled.  A few days before planting, sugarcane is harvested with the help of a tractor.  The depth of the khair usually ranges from 20 to 25 cm.  The distance between one CI center and the other CI center may be 45 ° C, 40 ° C, 40 ° C, 120 ° C, and now the CI / E is being used at higher intervals due to the fact that Kodakhusa and Hooda are being mechanically removed.  In the sugarcane area, 120 hectares are left to be eaten. The next time the soil falls from the hood, a good bed is made.  When the soil is submerged, the seeds are pushed into the soil by hand and foot.  The seedlings are planted on one side of the hood, and the seedlings die when the seeds fall in the middle of the seedlings, as the irrigation water in the seedlings is frequent and the seedlings are likely to germinate in this way.  Within 150 days of planting sugarcane, it is convenient to remove the last straw.  Farming in this way also saves water.  In the event of a flood, a single CIR irrigation can be arranged.  Weeds can be easily managed during the early stages of growth.  The weeds in the hood can be controlled by weeding before hooding.

 Paired row method.

 In this method, the distance between the two rows is about 75 cm.  One row pair contains 105 row m, the other row pair 105 m.  At such intervals, the plow is used to cut the plow, which is connected to the tractor.  If you cultivate in this way, it will take less water than the CIA method, and it will be easier to arrange drip irrigation at a lower cost.  Due to the good ventilation in the field, the number of pests is reducedred

 Transfer method

 This method has been used for rapid seed production.  Sugarcane seeds are planted directly in the basement without being planted in the field.  If possible, the seedlings are removed from the polythene sheet.  One-eyed sugarcane seeds are made.  Special methods are needed to prepare it.  This is because the eyes are more likely to explode when cut.  When the seedlings are 4 to 5 inches tall, they are planted in the field.  Seedlings are usually planted at a distance of 60 km in a row and at a distance of 45-60 cm from each tree.  Depending on the time of planting, the tree should be planted at the required intervals.  Seedlings can be produced by nourishment or colic drainage method, which takes only one-third of the seed required for the common method.  While the livelihoods are mainly limited to science, farmers are now able to produce sugarcane in the Kalika drainage system.